Blagdon-pump X15 PTFE Non-Metallic Manuel d'utilisateur

HG-CF-1119 Rev. F – 10.12.09 Page 1 All models, BSP Flanged models :- 1” ANSI 150. Atex Certified models. NOTE! Refer to pump Typical Code matrix o

HG-CF-1119 Rev. F – 10.12.09 Page 10 Flanged Manifolds Suction Lift Installation Flooded Suction Installation Submerged Installation Exhaust Safety :

HG-CF-1119 Rev. F – 10.12.09 Page 11 Performance Curve B15 Pump performance curve Performance based on waterat ambient temperature Re-Assembly of Ou

HG-CF-1119 Rev. F – 10.12.09 Page 12 IMPORTANT ! Read these instructions completely, before installation and start-up. It is the responsibility of th

HG-CF-1119 Rev. F – 10.12.09 Page 13 Atex Certified Models Take action to prevent static sparking. Fire or explosion can result, especially when han

HG-CF-1119 Rev. F – 10.12.09 Page 14 Wet Side Kit Structure Diaphragm Pump Wet-Side Kits - Part Number Structure The format of the Wet-Side kit part

HG-CF-1119 Rev. F – 10.12.09 Page 15 Date Details Completed Service / Maintenance Log RECYCLING Many components of BLAGDON air operated doubl

HG-CF-1119 Rev. F – 10.12.09 Page 16 Des Monaghan, Production & Technical Manager HG-CF-223 (REV 5) IDEX Pump Technologies (Ireland) Ltd., A Unit

HG-CF-1119 Rev. F – 10.12.09 Page 2 Contact Phone / E-Mail / Fax No. Contact Information Table of Contents Contact Information 2 Important warn

HG-CF-1119 Rev. F – 10.12.09 Page 3 Before pump operation, inspect all gasketed fasteners for looseness caused by gasket creep. Re-torque loose faste

HG-CF-1119 Rev. F – 10.12.09 Page 4 PRINCIPLE OF PUMP OPERATION This ball valve type diaphragm pump is powered by compressed air and is a 1:1 ratio

HG-CF-1119 Rev. F – 10.12.09 Page 5 TROUBLE SHOOTING GUIDE NOTE :- Check all solutions before dismantling the pump. PROBLEM CAUSE SOLUTION Pump wil

HG-CF-1119 Rev. F – 10.12.09 Page 6  Caution - Operating temperature limitations are as follows: Operating Temperatures Materials Maximum Minimum

HG-CF-1119 Rev. F – 10.12.09 Page 7 Dimension drawing - Standard Dimension drawing - Flanged - 1/2” ANSI 150 NOTE! All dimensions are +/- 2mm NOTE!

HG-CF-1119 Rev. F – 10.12.09 Page 8 Parts List - (Refer to Exploded view on page 9) - Indicates Torque setting required. See page 9 for details. B

HG-CF-1119 Rev. F – 10.12.09 Page 9 Exploded Assembly TORQUE SETTINGS A - 27 - 34 Nm (20 - 25 lbs/ft B - 6.2 - 6.7 Nm (55 - 60 lbs/in) C - 10 -